Log in or sign up
Declination and north

True, Grid and Magnetic North

True, grid and magnetic north are three different directions. Learn how they differ, how to read the map margin and how to convert them.

Updated: November 17, 2026

True north points to the geographic North Pole, grid north follows the vertical grid lines on your map, and magnetic north is where your compass needle points. The three rarely line up, so always check which north a bearing refers to.

The three norths side by side

NorthWhat it isWhere you meet it
True (geographic) northDirection to the geographic North Pole along a meridianStars, maps with a lat/long graticule, GPS files
Grid northDirection of the vertical lines of the map grid (for example UTM/MGRS)Grid lines on topographic maps
Magnetic northDirection the compass needle takes, following the Earth's magnetic fieldYour compass

A map is a flat picture of a curved Earth. Because of that projection, grid lines in most places do not run exactly along the meridians. The magnetic field has its own geometry again. The result is three directions that differ by small angles.

The three angles between them

  • Declination (true north to magnetic north): depends on place and year and changes slowly.
  • Grid convergence (true north to grid north): depends on the map projection and on how far you are from the central meridian of the zone. It is zero on that meridian and grows to a few degrees towards the zone edge.
  • Grid-magnetic angle (grid north to magnetic north): the angle you actually need when you transfer a grid bearing to your compass. It is the difference between declination and convergence.

Many topographic maps print these angles in a diagram in the margin: three arrows with values, the survey year and often the yearly change. Read the numbers, because the drawing is usually exaggerated and not to scale.

Conversion rules

Count east as positive and west as negative. To go from a grid bearing to a compass bearing:

  • If magnetic north lies east of grid north, subtract the grid-magnetic angle from the grid bearing.
  • If magnetic north lies west of grid north, add the angle.
  • From compass bearing to grid bearing, do the opposite.

A memory aid: with an east offset, the number gets smaller from map to compass; with a west offset it gets larger.

A fictional worked example

Say the margin diagram gives declination 3° east and convergence 1° east. The grid-magnetic angle is 3° − 1° = 2° east. You want to walk a grid bearing of 100°. Compass bearing = 100° − 2° = 98°. In reverse, if your compass reads 98°, the grid bearing is 100°. The numbers are invented; always use the values from your own map and year.

How much does it matter?

An angular error of 2° gives about 35 m of sideways drift after 1 km, and 3° gives well over 50 m. On short legs with visible landmarks you will hardly notice. On long legs in forest, fog or darkness it can take you past your objective. A typical hand compass cannot be read to a single degree either, so the smallest angles disappear in that reading error.

Common mistakes

  1. Mixing up true and magnetic north: a bearing from a GPS app or online tool is often relative to true north. Check the setting.
  2. Using the wrong sign: swapping east and west doubles the error instead of removing it.
  3. Trusting an old margin blindly: declination changes; update the value for the year of your trip.
  4. Mistaking interference for declination: steel, vehicles and power cables cause local deviation that a fixed angle does not fix.

Which north will you meet where?

A GPS file or a graticule uses true north, a grid such as MGRS uses grid north, and your compass uses magnetic north. So whenever someone passes you a bearing, ask which north it refers to. A route description or an app that just says "north" is incomplete. In a team, agree on which north you use and write it next to every bearing, for example as "TN", "GN" or "MN". That prevents misunderstandings between people who each use a different tool.

In MilMap

MilMap shows MGRS coordinates and the magnetic declination for your location, which makes it easier to translate a grid bearing to your compass. Use it as an aid next to a physical compass and check against landmarks as you go.

Try it in MilMap

Combine your map and compass with MilMap: declination, MGRS and offline maps.

Or download the app

Frequently asked questions

What is the difference between true north and magnetic north?

True north points to the geographic North Pole; magnetic north is where the Earth's magnetic field pulls your compass needle. The angle between them is the declination, which varies by place and year.

What is grid north?

Grid north is the direction of the vertical lines of the map grid, such as UTM or MGRS. Because of the projection it differs slightly from true north; that angle is the grid convergence.

Which north do I use with a map and compass?

Your compass shows magnetic north and your map grid is grid north. Use the grid-magnetic angle from the map margin to convert between them.

Do I always need to correct for it?

Not always. On short legs with visible landmarks it is usually unnecessary. On long legs, in poor visibility or when plotting bearings on a map, a correction is wise.

Sources and disclaimer

  • Based on publicly available knowledge, rewritten in our own words. Not an official publication.