Log in or sign up
Basics: the compass

How to Hold and Read a Compass

Hold a compass level, read the bearing correctly and avoid common mistakes caused by metal, tilt and rushing. Step by step.

Updated: November 15, 2026

Hold the compass level at about waist height, away from metal, with the direction-of-travel arrow pointing away from you; wait until the needle settles and read the bearing at the index line. When aiming, turn your whole body, not just the compass.

Step 1: Choose a good spot

Metal and electronics disturb the needle. Keep a few metres from vehicles, fences and power lines, and put your phone, belt buckle, a watch with a magnetic clasp or a tool aside. If in doubt, walk a few steps away and see whether the needle settles differently. If it does, there was interference.

Step 2: Keep the compass level

The needle only turns freely when the housing is flat. Hold the compass with both hands or on an open palm, at about waist height, and check that the bubble (on models that have one) does not drift too far. If the needle touches the bottom or the rim of the capsule, the compass is tilted. Press your elbows against your body for a steady stance.

Step 3: Arrow away from you

The direction-of-travel arrow on the baseplate always points the way you look or walk. Keep it straight out in front, in line with your belly or nose. Hold the compass at an angle and you measure a wrong bearing without noticing.

Step 4: Turn yourself, not the compass

To find a direction, turn your whole body while the compass stays still in your hands. That keeps the angle between the arrow and your body constant. Let the needle come to rest; with a liquid-filled capsule that takes a few seconds.

Step 5: Red in the shed

Turn the bezel until the red end of the needle sits exactly inside the orienting arrow. A well-known memory aid is red in the shed: the needle is the red, the orienting arrow is the shed. Make sure you use the red end, not the end that points south.

Step 6: Read at the index line

Read the degrees where the index line meets the bezel. Look straight down on it to avoid parallax errors. Write the bearing down at once, for example "bearing 135 degrees". A bearing runs from 0 to 360; south is about 180, east about 90, west about 270. Do a sanity check: if you are walking towards the late-afternoon sun, the bearing should lie roughly towards the west.

Back bearing and declination

You find the opposite direction (a back bearing) by adding 180 degrees if the bearing is below 180, and subtracting 180 if it is above. A compass points to magnetic north, which differs from the north on the map. That difference is declination. When transferring a bearing to or from a map, take it into account; many maps print the value in the legend, and it changes slowly over time.

Common mistakes

MistakeResultFix
Compass tiltedNeedle drags or gives a wrong directionKeep it level, elbows in
Metal or phone nearbyDeviation you do not noticeKeep your distance and check at a second spot
Turning only the compassArrow does not point where you lookTurn your body, keep the compass still
Mixing up red and southBearing 180 degrees outCheck red is in the orienting arrow
Forgetting declinationSystematic errorApply the correction to every bearing
RushingReading before the needle has settledWait a moment, then read

Practice pays off

Try it first on familiar ground: pick a tree or a post, measure the bearing to it and check by walking there. That builds confidence and shows how much error you introduce yourself. Practise with cold or wet hands too, so you are not working that way for the first time in bad weather.

In MilMap

In MilMap you see your live position and the magnetic declination for your location, so you can convert a bearing you have read to the map more quickly. You can plan routes and waypoints and keep map regions offline. It remains a complement: practise with a real compass as well.

Try it in MilMap

Combine your map and compass with MilMap: declination, MGRS and offline maps.

Or download the app

Frequently asked questions

How do I read a compass?

Hold it level, wait for the needle to settle, turn the bezel until the red needle sits in the orienting arrow, and read the degrees at the index line.

Why does my needle point the wrong way?

Often because of metal, magnets or electronics nearby. Move a few steps away and check again.

Should I turn the compass or myself?

Turn yourself. Keep the compass still in front of your body so the arrow points where you are looking.

What is a back bearing?

The opposite of your bearing: add or subtract 180 degrees so the result stays between 0 and 360.

Sources and disclaimer

  • General knowledge about compass use, in our own words. Handling differs slightly by model.